Hiland HLDS032-B Зөөврийн ширээний халаагуурын зааварчилгааны гарын авлага

1. Танилцуулга

This manual provides essential information for the safe assembly, operation, maintenance, and troubleshooting of your Hiland HLDS032-B Portable Table Top Patio Heater. Please read all instructions carefully before use and retain this manual for future reference.

The Hiland HLDS032-B is a compact, portable propane-fueled heater designed for outdoor use, providing 11,000 BTUs of heat. It is suitable for placement on tabletops and can operate with either a 1lb propane tank or a 20lb propane tank (with an adapter hose, not included).

2. Аюулгүй байдлын мэдээлэл

WARNING: For Outdoor Use Only. Do not operate this heater indoors or in enclosed spaces.

• Халаагчийг ажиллуулахдаа агааржуулалтыг үргэлж хангалттай байлгах хэрэгтэй.
• Keep clear of combustible materials. Maintain a minimum clearance of 24 inches (61 cm) from sides and rear, and 36 inches (91 cm) from the top.
• This heater is equipped with a thermocouple and anti-tilt safety devices, which will automatically shut off the gas supply if the pilot flame extinguishes or the unit tips over.
• Энэ болон бусад хэрэгслийн ойролцоо бензин болон бусад шатамхай уур, шингэнийг бүү хадгал.
• Propane gas is heavier than air and will settle in low areas. Ensure the area around the heater is clear of any potential ignition sources.
• Always inspect the gas hose and connections for leaks before each use. Use a soapy water solution to check for bubbles.
• Халаагуурыг засах эсвэл өөрчлөх гэж бүү оролд. Засварын талаар мэргэшсэн үйлчилгээний ажилтантай холбогдоно уу.
• Ашиглалтын явцад хүүхэд, тэжээвэр амьтдыг халаагчаас хол байлга.
• Энэ бүтээгдэхүүн нь Калифорни мужид хорт хавдар, ургийн гажиг эсвэл нөхөн үржихүйн бусад хор хөнөөл учруулдаг химийн бодис агуулдаг (Санал 65 анхааруулга).

3. Багцын агуулга

Verify that all components are present and undamaged before assembly. If any parts are missing or damaged, do not proceed with assembly; contact customer service.

• Heater Head Assembly (Burner, Reflector, Screen Guard)
• Үндсэн хэсэг/орон сууц
• Суурь хавтан
• Heavy Weight Plate for Stability
• Зохицуулагч
• Тоног төхөөрөмжийн багц (эрэг, түлхүүр)
• Зааварчилгааны гарын авлага

4. Угсрах ба тохируулах

Follow these steps for proper assembly and initial setup of your patio heater.

4.1 Attaching the Base and Weight Plate

1. Бүх бүрэлдэхүүн хэсгүүдийг болгоомжтой задлаарай.
2. Attach the heavy weight plate to the underside of the base plate using the provided hardware. This plate significantly enhances stability.
3. Secure the main body/housing to the base plate.

4.2 Installing the Propane Tank

The heater is designed to use a 1lb propane tank directly or a 20lb propane tank with an optional adapter hose (not included).

1. Хяналтын бариул "OFF" байрлалд байгаа эсэхийг шалгаарай.
2. Open the access door on the main body of the heater. This door provides easy access to the propane connection point.
3. Connect the regulator to the propane tank. For a 1lb tank, screw it directly into the regulator. For a 20lb tank, connect the adapter hose to the tank and then to the regulator.
4. Carefully place the propane tank inside the heater's housing. The regulator may tilt for easier installation.
5. Нэвтрэх хаалгыг найдвартай хаа.

4.3 Нэвчилтийн туршилт

Before first use and after every tank change, perform a leak test:

1. Mix a solution of soapy water (50% soap, 50% water).
2. Ensure the heater's control knob is OFF.
3. Пропан савны хавхлагыг нээ.
4. Apply the soapy solution to all gas connections. If bubbles appear, there is a leak. Tighten connections or replace parts as necessary. Do not operate the heater if a leak is detected.

5. Ашиглалтын заавар

This section details how to safely ignite and operate your Hiland patio heater.

5.1 Гал асаах журам

It is recommended to perform the initial ignition in low light conditions to clearly see the pilot flame.

1. Пропан савны хавхлага бүрэн нээлттэй байгаа эсэхийг шалгаарай.
2. Push in the control knob and rotate it counter-clockwise to the "PILOT" position.
3. While holding the knob in, press the red igniter button repeatedly until the pilot flame ignites. You may need to press it multiple times (up to 15-20 times) until you hear a click and see the pilot light.
4. Once the pilot is lit, continue to hold the control knob in for at least 15-20 seconds. This allows the thermocouple to heat up and engage the safety valve. Releasing too soon will cause the pilot to extinguish.
5. After holding, slowly release the control knob. The pilot flame should remain lit. If it extinguishes, repeat steps 2-4.
6. To ignite the main burner, push in the control knob and rotate it further counter-clockwise to the "LOW" or "HIGH" position. The main burner should ignite.

5.2 Adjusting Heat Output

Rotate the control knob between "LOW" and "HIGH" to adjust the heat intensity as desired. The heater provides up to 11,000 BTUs of heat.

5.3 Халаагчийг унтраах

1. Rotate the control knob clockwise to the "OFF" position.
2. Пропан савны хавхлагыг хаа.
3. Халаагчийг зөөх эсвэл хадгалахын өмнө бүрэн хөргөнө.

6. Засвар үйлчилгээ

Тогтмол засвар үйлчилгээ нь таны халаагуурын аюулгүй, үр ашигтай ажиллагааг хангана.

• Цэвэрлэгээ: Гадна гадаргууг зөөлөн арчиж, damp cloth. Do not use abrasive cleaners or solvents. Ensure the burner screen is free of debris.
• Хадгалах: When not in use for extended periods, disconnect the propane tank and store the heater in a dry, protected area.
• Хяналт шалгалт: Periodically check all gas connections and the hose for signs of wear, damage, or leaks.

7. Алдаа засах

Нийтлэг асуудлууд болон тэдгээрийн шийдлүүдийг энэ хэсгээс харна уу.

8. Техникийн үзүүлэлтүүд

9. Баталгаат хугацаа ба дэмжлэг

Hiland products include a one-year warranty against manufacturer defects. AZ Patio Heaters LLC maintains a complete line of replacement parts and a full-service repair center.

For warranty claims, replacement parts, or technical support, please contact Hiland customer service. Refer to your purchase documentation for contact details.