Donner DWS-3 UHF утасгүй гитарын системийн зааварчилгааны гарын авлага

Танилцуулга

Thank you for choosing the Donner DWS-3 UHF Wireless Guitar System. This manual provides essential information for the proper setup, operation, and maintenance of your device. Please read it thoroughly before use to ensure optimal performance and longevity of the product.

Бүтээгдэхүүн дууссанview

Гол онцлогууд:

• Ultra-short latency: Less than 2.5ms for high-quality tone.
• Extended range: Over 100 feet (approximately 30 meters) for uncompressed wireless transmission.
• Long battery life: Built-in rechargeable lithium battery provides up to 6 hours of continuous use.
• Multiple channels: Supports 4 sets of devices operating simultaneously without interference.
• Rotatable plug: 225° rotatable 1/4" plug for compatibility with various electric instruments.

Бүрэлдэхүүн хэсгүүд:

The Donner DWS-3 system includes a transmitter (DWS-3T) and a receiver (DWS-3R).

Figure 1: Donner DWS-3T Transmitter (left) and DWS-3R Receiver (right).

Each unit features a 1/4" jack, power switch, channel selection button, and LED indicators for battery and channel status.

Тохиргоо

1. Төхөөрөмжийг цэнэглэх:

The DWS-3 units are equipped with built-in rechargeable lithium batteries. Before initial use, fully charge both the transmitter and receiver.

• Connect the provided USB charging cable to the Micro USB port on each unit.
• USB кабелийн нөгөө үзүүрийг тохирох USB тэжээлийн адаптер (дагалдахгүй) эсвэл компьютерын USB порт руу залгана уу.
• Бүрэн цэнэглэхэд цэнэглэх хугацаа ойролцоогоор 2 цаг байна.
• LED indicators will show charging status and battery level.

Figure 2: The included USB charging cable for the DWS-3 units.

2. Хэрэгсэлд холбогдох болон Ampамь нас:

1. Transmitter (DWS-3T): Plug the transmitter into your electric instrument's output jack (e.g., electric guitar, bass, electric-acoustic guitar). The 225° rotatable plug allows for optimal positioning on various instrument body shapes.
2. Receiver (DWS-3R): Plug the receiver into the input jack of your amplifier, effects pedal, or audio interface.

Figure 3: Transmitter connected to a guitar and receiver connected to an ampнастан.

3. Pairing and Channel Selection:

The DWS-3 units are typically pre-paired from the factory. If re-pairing is needed or to change channels:

1. Turn on both the transmitter and receiver using their respective power switches.
2. Press the "CH SEL" (Channel Select) button on both the transmitter and receiver simultaneously until their channel indicators match (CH1, CH2, CH3, or CH4).
3. The units will automatically pair on the selected channel. A solid green light on the RX indicator (receiver) and TX indicator (transmitter) confirms a successful connection.

Figure 4: LED indicators for channel selection and battery status on the DWS-3 units.

The DWS-3 supports up to 4 sets of devices working simultaneously. Ensure each set is on a different channel to avoid interference.

Figure 5: Illustration of multiple DWS-3 systems operating on separate channels.

Ашиглалтын заавар

Once the transmitter and receiver are connected, you can begin playing your instrument wirelessly. The system provides uncompressed signal transmission with minimal latency.

Adjusting the Plug:

The 1/4" plug on both units can rotate 225 degrees. This feature allows you to position the units optimally, preventing them from interfering with your playing or the instrument's controls.

Figure 6: The 225° rotatable plug for flexible positioning.

Засвар үйлчилгээ

Батерейны арчилгаа:

• To prolong battery life, avoid completely draining the units regularly.
• Charge the units when the battery indicator shows low power.
• If storing the units for an extended period, ensure they are partially charged (around 50%) to prevent battery degradation.

Цэвэрлэгээ:

Wipe the units with a soft, dry cloth. Avoid using harsh chemicals or abrasive materials that could damage the finish.

Алдааг олж засварлах

• No Sound/Intermittent Signal:
  • Ensure both units are powered on and fully charged.
  • Verify that the transmitter and receiver are paired to the same channel.
  • Check for potential interference from other wireless devices (Wi-Fi routers, other wireless systems). Try switching to a different channel.
  • Ensure the units are within the 100-foot operating range and there are no major obstructions.
• Static or Noise:
  • Change the operating channel to avoid interference.
  • Ensure the units are not too close to strong electromagnetic fields.
  • Check the instrument's output and amplifier's input for any issues.
• Батерейны богино хугацаа:
  • Ensure the units are fully charged before use (approx. 2 hours).
  • Батерейг удаан хугацаагаар ашигласнаар цаг хугацааны явцад ашиглалтын хугацаа муудаж болзошгүй.

Үзүүлэлтүүд

Бүтээгдэхүүний албан ёсны видеонууд

The following videos are provided by the manufacturer to assist with product understanding and usage.

Баталгаат болон дэмжлэг

Specific warranty details for the Donner DWS-3 Wireless Guitar System are not provided in the product information. Please refer to the official Donner website or contact customer support for detailed warranty information and support services.

Нэмэлт тусламж авахыг хүсвэл зочилно уу Donner Store on Amazon or consult the included owner's manual for contact information.