1. Танилцуулга
This manual provides essential information for the proper installation, operation, and maintenance of your FireAngel CO-9B Carbon Monoxide Detector. Carbon monoxide (CO) is a colorless, odorless, and tasteless gas that can be fatal. This detector is designed to alert you to the presence of CO gas, helping to protect you and your family from its dangers. Please read this manual thoroughly before using the device and retain it for future reference.
Зураг 1.1: Урд view of the FireAngel CO-9B Carbon Monoxide Detector.
2. Тохиргоо ба суурилуулалт
2.1 Багцын агуулга
Таны багц дараах зүйлсийг агуулж байгаа эсэхийг шалгана уу.
- FireAngel CO-9B Carbon Monoxide Detector
- Холбох эрэг ба хананы залгуур
- Зааварчилгааны гарын авлага
Image 2.1: Included items: detector, mounting hardware, and manual.
2.2 Батерей суурилуулах
The FireAngel CO-9B requires two (2) AA batteries (not included). Follow these steps:
- Илрүүлэгчийн ар талд байрлах батерейны хэсгийг олоорой.
- Зайны тасалгааны тагийг нээ.
- Insert two new AA batteries, ensuring correct polarity (+ and -).
- Зайны тасалгааны тагийг сайтар хаа.
2.3 Хамгийн оновчтой байршил
For optimal protection, install CO detectors in the following locations:
- Танай гэрийн бүх давхарт, түүний дотор подвалд.
- Near or in every sleeping area.
- Near potential sources of CO, such as gas appliances, fireplaces, and attached garages.
Avoid these locations:
- Within 1 meter (3 feet) of cooking appliances, heating appliances, or open flames.
- In extremely dusty, dirty, or greasy areas.
- Нарны шууд тусгалд эсвэл температурын огцом өөрчлөлтөд өртөмтгий газарт.
- In areas with high humidity, such as bathrooms.
- Behind curtains or furniture that could obstruct the sensor.
Image 2.2: Detector placement in a sleeping area.
Image 2.3: Detector placement in a kitchen area.
2.4 Илрүүлэгчийг суурилуулах
Once you have chosen an appropriate location, mount the detector:
- Mark the positions for the mounting screws on the wall or ceiling.
- Drill holes and insert the wall plugs if necessary.
- Secure the mounting bracket (if applicable) or the detector directly using the provided screws.
- Attach the detector to the mounting bracket or wall/ceiling by twisting it into place until it clicks securely.
3. Ашиглалтын заавар
3.1 Power-On and Normal Operation
After battery installation, the detector will perform a self-test. The power indicator light (usually green) will flash periodically, indicating normal operation. If any issues are detected during the self-test, refer to the Troubleshooting section.
3.2 Дохиоллыг турших
It is crucial to test your CO detector weekly to ensure it is functioning correctly.
- Press and hold the 'TEST/RESET' button on the front of the detector for a few seconds.
- The alarm will sound a loud, distinct pattern, and the alarm indicator light (usually red) will flash.
- Release the button. The alarm will stop, and the detector will return to normal operation.
Image 3.1: Pressing the 'TEST/RESET' button.
3.3 Нүүрстөрөгчийн дутуу ислийн дохиолол
If the detector senses a dangerous level of CO, it will activate the alarm:
- The alarm will emit a loud, continuous sound pattern (e.g., 4 quick beeps, pause, 4 quick beeps).
- The alarm indicator light (red) will flash rapidly.
What to do if the alarm sounds:
- Нэн даруй цэвэр агаарт гарах эсвэл бүх хаалга, цонхыг онгойлгох хэрэгтэй.
- Бүх хүнийг бүртгэсэн эсэхийг шалгахын тулд хүн амын тооллого хийнэ үү.
- Do not re-enter the premises until it has been aired out and the CO source has been identified and corrected.
- Seek medical attention for anyone experiencing symptoms of CO poisoning (headache, nausea, dizziness).
- Contact the appropriate emergency services or a qualified technician to investigate the source of CO.
Image 3.2: Common sources of carbon monoxide.
3.4 Silence/Reset Function
Pressing the 'TEST/RESET' button during an alarm will temporarily silence the alarm for a short period (e.g., 5-10 minutes). This function is useful for investigating the source of CO. If the CO level remains high, the alarm will reactivate.
4. Засвар үйлчилгээ
4.1 Тогтмол шинжилгээ
Test your CO detector weekly by pressing the 'TEST/RESET' button as described in Section 3.2.
4.2 Илрүүлэгчийг цэвэрлэх
Clean the detector regularly to prevent dust and debris from interfering with its operation. Use a soft, damp cloth to wipe the exterior. Do not use cleaning solvents or sprays directly on the detector.
4.3 Батерейг солих
The detector will emit a short chirp every 30-60 seconds and the low battery indicator light (usually amber) will flash when the batteries are low. Replace both AA batteries immediately following the instructions in Section 2.2.
4.4 Ашиглалтын хугацаа дууссаны дохио
The FireAngel CO-9B has a typical lifespan of 7 years. When the detector reaches its end-of-life, it will emit a specific end-of-life signal (e.g., two chirps every 30 seconds). When this occurs, the detector must be replaced immediately.
5. Алдаа засах
Нийтлэг асуудлууд болон тэдгээрийн шийдлүүдийг доорх хүснэгтээс харна уу.
| Асуудал | Indicator/Sound | Боломжит шалтгаан | Шийдэл |
|---|---|---|---|
| No power/No lights | Байхгүй | Батерейг суулгаагүй эсвэл дуусаагүй байна | Install new AA batteries correctly. |
| Батарей бага байгааг анхааруулж байна | Chirp every 30-60 seconds, amber light flashes | Батерей бага байна | Хоёр АА батерейг нэн даруй солино уу. |
| CO Alarm sounds | Loud, continuous alarm, red light flashes | Нүүрстөрөгчийн дутуу исэл илэрсэн | Follow 'What to do if the alarm sounds' in Section 3.3. Evacuate and seek professional help. |
| Амьдралын төгсгөлийн анхааруулга | Two chirps every 30 seconds | Detector has reached its operational lifespan | Replace the detector immediately. |
| Intermittent chirping (not low battery or end-of-life) | Single chirp, no specific light pattern | Dust, debris, or sensor fault | Clean the detector. If chirping persists, replace the unit. |
6. Техникийн үзүүлэлтүүд
| Онцлог | Дэлгэрэнгүй |
|---|---|
| Загвар | FireAngel CO-9B |
| Хэмжээ (L x W x H) | 11.5 x 3.9 x 13.8 см |
| Жин | 127.01 грамм |
| Эрчим хүчний эх үүсвэр | 2 х АА батерей (оруулаагүй) |
| Мэдрэгчийн төрөл | Электрохимийн |
| Сэрүүлгийн дууны түвшин | Typically 85 dB at 3 meters (10 feet) |
| Ашиглалтын температур | Ерөнхийдөө 0°C-аас 40°C (32°F-ээс 104°F) |
| Ашиглалтын чийгшил | Typically 30-90% RH non-condensing |
| Бүтээгдэхүүний амьдрал | Идэвхжүүлснээс хойш 7 жил |
| UPC | 816317003777 |
7. Баталгаат хугацааны мэдээлэл
For detailed warranty information, please refer to the documentation included with your product or visit the official FireAngel website. Warranty terms typically cover defects in materials and workmanship under normal use. Please note that information regarding spare parts availability is not provided in the product specifications.
8. Дэмжлэг
If you have any questions or require technical assistance with your FireAngel CO-9B Carbon Monoxide Detector, please contact FireAngel customer support through their official website or the contact details provided in your product packaging. Always provide your model number (CO-9B) when seeking support.
